Search:     Advanced search
Mirage Amplifiers
 
document KB0161 Mirage Amplifier Doorbell Preset Wiring
Both the M-400 and M-800 series amplifiers offer a doorbell feature. With this feature a preset doorbell sound can be played out of a select group of zones or all the zones in the system by triggered contact closure. The type of doorbell sound, volume level and zones will be configured under the...
17 Apr, 2018 Comments: 0
document KB0191 How to Update E-series Amplifier Firmware (M-801e, M-401e, M-120e Amplifiers)
Updated: 03/01/2017 Category: Mirage Amplifiers Products: Mirage M-801e, M-401e, M-120e Use the following procedure to update the firmware on your Mirage Audio System amplifiers - M-801e, M-401e, M-120e.  Your settings will NOT be erased.  Please leave your amps...
01 Mar, 2017 Comments: 0
document KB0078 How to Update Amplifier Firmware (M800, M400 Amplifiers)
Updated: 06/22/2015 Category: Mirage Amplifiers Products: Mirage M800, M400 Use the following procedure to update the firmware on your Mirage Audio System amplifiers - M800, M400.  Your settings will NOT be erased.  Please leave your amps fully attached and...
01 Mar, 2017 Comments: 0
document KB0186 Network and Port Requirements for eSeries MAS
Required Settings for eSeries Mirage Audio System to enable communication between eSeries servers and eSeries amplifiers. Multicast (UDP) communication is required between servers and amplifiers on 239.195.188.235 The necessary communication port for this UPD traffic is defined as...
10 Feb, 2017 Comments: 0
document KB0187 Factory Resetting Mirage Amplifiers
Factory Resetting Mirage Amplifiers Updated: 2016-12-09 Category: Mirage Amplifiers Products: M400, M800, M801e, M401e, M120e  Problem Description I need to factory reset my amplifier. Resolution There are two ways to factory reset a Mirage Amplifier. If...
09 Dec, 2016 Comments: 0
document KB0168 Turn Off Skip Next button on KP-6 Keypad
By default, on the Autonomic KP-6, the Skip Next button will skip to the next track in the now playing queue or on the streaming service.(Top right button).  In some installations, it may be desirable to disable this option.    To configure the Keypad to disable the Skip Next...
19 Mar, 2016 Comments: 0
document KB0167 Allow KP-6 Keypad Presets to Act as Source Selection
By default, on the Autonomic KP-6, the numbered preset buttons (Buttons #1 through #4) act as Presets.  In some installations, it may be desirable to have these numbered buttons select a Source rather than a Preset.   To configure the Keypad to toggle between Source...
09 Mar, 2016 Comments: 0
document KB0151 Mirage Amplifier Expansion Cable Length
The expansion cable between a stack of amplifier should be no longer than half a meter. A expansion cable longer than the recommend size will result in issues including zone's not properly populating in the amplifier configuration page.
21 Apr, 2015 Comments: 0
document KB0148 Amplifier Warning Notice For Installers
NOTICE! AUTONOMIC MIRAGE AMPLIFIERS MODEL NUMBERS: M-400 AND M-800 DO NOT SHORT SPEAKER NEGATIVE TERMINALS Use of any devices that use a common ground including, but not limited to, speaker level volume controls, speaker selectors and speaker level subwoofer connections are NOT...
11 Feb, 2015 Comments: 0